Recent content by Lee Godwin

I don't disagree with you. The question I answered was if the default setting was -5 and my thoughts on 5% being way too high for my liking.

The default setting is 0. You must change that to anything greater than 0 in order for it to work. Personally I think 5% is way too big a risk for any account. I would use -2 (2%) or a set number like .5. Just my thoughts though.

Yes. That is what mine says also. I do not understand why yours is not replicating.

My FINFX is in a buy EURUSD as of this post.

Mine replicated again. My earlier GPDUSD took a $63.00 profit. I also have a USDCHF going right now. Dont know why yours is not replicating my friend. Are all your bells and whistles flashing?

Mine replicated and is trading now. I am using MB Trading. However; I am also running it on a FINFx account and it did not make the trade. So go figure.

I have done as you suggested. I can only get one instance of the mt4 (mbtrading) to run at one time. Any suggestions on what I need to do to have two instances running at the same time??

I have no problem running both pairs in finfx but cannot do the same in mbtrading. Only difference in the two is finfx allows hedging mbtrading does not.

I got it. I updated. Now I cant keep 2 windows open at the same time without crashing. Before I could keep 4 open.

Not sure how you can trade on a chart that is not open. I have had 4 charts open for a couple of days now without it crashing. No trades either though. But no crashes.